Correcting Colors for Each Paper Type

Perform optimum color correction for each paper type.
Prepare the following paper.
Paper to correct colors with using this correction (any of thin paper, plain paper, thick paper, recycled paper, matte photo paper)
A3 or 11x17 is recommended.
Size: any of A3, 11x17, LTR, or A4
Sheets: 2
Correction for single paper types is not available while scanning or printing is performed.
1
Load paper in a paper drawer or the multi-purpose tray.
Make paper settings also. Loading Paper
2
Select <Menu> in the Home screen. Home Screen
3
Select <Adjustment/Maintenance> <Adjust Image Quality> <Color Correction>  <Auto (Pattern Scan)>.
4
Select <Single Paper Type>.
5
Select the paper type.
6
Check that the size and type of paper displayed on the screen is loaded in the machine, and select <OK>.
7
Confirm the procedure, and select <Start>.
The first adjustment image is printed.
8
When the screen <Processing... Do not turn OFF the device.> is displayed, wait about 2 minutes before going to the next operation.
9
When the screen <Place the 1st alignment pattern as shown and scan it.>, open the feeder.
10
Place the first adjustment image on the platen glass.
Place the adjustment image with the print side facing down and the mark in the upper left corner of the machine.
11
Gently close the feeder.
12
Select <Start Scanning>.
The placed adjustment image is scanned, and then the second adjustment image is printed.
13
When the screen <Processing... Do not turn OFF the device.> is displayed, wait about 2 minutes before going to the next operation.
14
When the screen <Place the 2nd alignment pattern as shown and scan it.>, open the feeder, remove the first adjustment image, and then place the second adjustment image on the platen glass.
In the same way as for the first adjustment image, place the adjustment image with the print side facing down and the mark in the upper left corner of the machine.
15
Gently close the feeder.
16
Select <Start Scanning>.
The placed adjustment image is scanned and adjustment starts.
17
When a message appears notifying that adjustment is complete, open the feeder, and remove the second adjustment image.
18
Gently close the feeder.
If the <Could not perform correction.> message is displayed
Did you load the paper displayed in step 5 into the paper source?
Did you place the adjustment image with the print side face down, with the mark in the upper left corner of the machine?
Is the printout soiled?
If this does not correct color unevenness
Print out a nozzle check pattern and check that no miscolored lines are present (Checking the Condition of the Nozzles). Next perform correction for all paper types again.
To return corrected values to initial values
In the <Auto (Pattern Scan)> screen, select <Restore Initial Settings>.
2579-0JJ