Checking the Send and Save Status and Log of Scanned Data
Sending/saving scan data and other processes done by the printer are managed as jobs. Checking job statuses and logs allows you to see that sending/saving has been done correctly, or see the cause of an error.
This operation is available using the operation panel or Remote UI.
Important
-
Check the status of sending/saving from the operation panel.
-
If you have set the log not to be displayed, only the send/save status can be viewed
Using Operation Panel
-
In the Home screen or the Overview screen, select Status Monitor.
-
Select TX Job.
-
Select TX Job Status or TX Job Log.
TX Job Status allows you to check jobs in progress and queued jobs.
TX Job Log allows you to check completed send/save jobs.
-
Select a job with details you want to check.
-
Check the status and log from the displayed information.
-
If Error is displayed in the send/save log
Either sending/saving was stopped, or an error occurred. If a 3-digit number starting with "#" (an error code) is displayed, you can check the cause and how to remedy it from the error code.
Note-
Select Regst to Add Book in the screen with details for a completed send/save job to register the destination to the address book.
-
If scan data has several destinations, press Destination to display a list.
-
-
Using Remote UI
-
Start up Remote UI.
-
Select Status Monitor/Cancel.
-
In TX, select Job Log.
-
Check the status and log for the job.
