Automatic Adjustment to Straighten Lines and Align Colors

If printed vertical lines are warped or colors are out of alignment, execute Print Head Alignment and adjust the print head position.

Choose from Auto (standard) or Auto (advanced) for automatically adjusting the print head.

Minor warping and misaligned colors can usually be improved by executing Auto (standard). If there is no improvement, perform Auto (advanced) or Manual.

• Manual Adjustment to Straighten Lines and Align Colors

When you execute Auto (standard) or Auto (advanced), the adjustment pattern is printed, and the print head position is adjusted based on the printing result automatically.

Important

• If the situation is difficult, such as the lines being misaligned, or color unevenness does not improve even after executing Print Head Alignment, execute Print head angle adjustment and then execute Print Head Alignment again.

  • Adjusting Line Misalignment
• Because the results of adjustment vary depending on the type of paper used for adjustment, use the same type of paper as you will use for printing.
• This function is not available for paper with high transparency.

Note

• After print head replacement, we recommend executing Print Head Alignment. When Print pattern after new head is set to ON, print head position adjustment is automatically executed after print head replacement.
• To change the paper type or for more beautiful color borders, perform Auto (standard).
• To ensure clear quality and when replacing the print head, perform Auto (advanced) to fine-tune the position between nozzles and colors. To ensure high-quality printing, we recommend that you execute Auto (advanced).

• If adjustment is not possible as expected using special paper, try another type of paper or try Manual adjustment.

  • Manual Adjustment to Straighten Lines and Align Colors

• After performing Print Head Alignment, it is recommended to set Ink ejection status check to Display warning.

  A notification about adjustment timing will be sent when the print head ejection status changes.

  • Auto maintenance settings

Paper to Prepare

When using rolls

An unused roll at least 23.39 in. (594.0 mm) wide

When using sheets

Auto (standard): One sheet of unused paper, A2 size or larger

Auto (advanced): Two sheets of unused paper, A2 size or larger

Perform adjustment as follows.

1. Load paper.

   When loading cut sheets, set them in landscape orientation.

   • Loading Rolls in the Printer
   • Loading Sheets in the Printer

   Important

   • Always make sure the loaded paper matches the type of paper specified on the printer. Adjustment cannot be completed correctly unless the loaded paper matches the settings.

2. Attach the basket.

   • Using the Basket on the Front of the Printer

3. Select Maintenance on HOME screen.

4. Select Print Head Alignment.

5. Select Auto (standard) or Auto (advanced).

   A confirmation message appears.

6. Select Yes.

   The paper source setting screen appears.

7. Select Roll paper 1, Roll paper 2 or Manual.

   A test pattern is printed for adjustment.

   The print result is output from the front of the printer.