Copying Four Pages onto Single Page
When you select 4-on-1 copy for Layout in Standard copy, you can copy four original pages onto a single sheet of paper by reducing each image. Four different layouts are available.
Select Settings in the Copy standby screen to display the print settings screen, select 4-on-1 copy for Layout, and then select OK.
If you select Advanced with 4-on-1 copy selected, you can specify the orientation and the order of the original.
Note
-
The order is the same regardless of the orientation.
-
When you select Upper-left to right
-
When you select Upper-right to left
-
When you select Upper-left to bottom
-
When you select Upper-right to bottom
After selecting the order, you can select whether you use the preview screen. If you select ON, the preview screen is displayed so that you can check the orientation.
Note
-
If Device memory is full. Cannot continue process. appears on the touch screen when scanning, set Print qlty to Standard and try copying again. If the problem is not resolved, set Print qlty to Draft and try copying again.
-
This function can be used in combination with Two-sided copy.
If you use this function in combination, you can copy eight original pages on one sheet of paper. In this case, four original pages are copied on each side of paper.
If you use this function in combination, select 2-sided for 2-sidedPrintSetting and select the orientation and the stapling side of print paper on the print settings screen.
For more on two-sided copy function:
When Loading Originals on Platen:
-
Before scanning:
When you are using the preview screen, the screen below is displayed before copying starts so that you can check the orientation.
-
A: Select to rotate the original by 180 degrees.
-
B: Select to start scanning the original.
-
C: Select to rescan the original.
-
-
After scanning:
The screen below appears after scanning each sheet of original.
-
A: Select to start scanning the original.
Remove the sheet of original from the platen after scanning and load the next sheet on the platen and select Scan.
-
B: Select to start copying the original already scanned.
After scanning the fourth sheet of original, the printer starts copying.
Note-
You can add the copying job while printing.
-
If you use this function in combination with Two-sided copy, the screen above is displayed after scanning the fourth sheet of original is complete. Follow the on-screen instructions to scan the rest of originals.
-
When Loading Two-sided Documents in ADF:
After scanning of the front sides of the document pages is finished, an on-screen guide showing how to load the back sides of the document pages appears.
Remove the documents from the document output slot, load them in the document tray without changing their orientation, and then select Scan. The printer starts scanning the back sides of the document pages.
