Wi-Fi Lamp Is Lit

1. Check1 Check the wireless router's settings.

   The lamp also lights up when wireless connection settings were not completed within 10 minutes after releasing the RESUME/CANCEL button.

2. Check2 Is the wireless router turned on?

   If it is already turned on, turn it off, and then turn it back on.

   Do not proceed to the next screen of this guide until the power is turned on. The connection to the wireless router will be temporarily disabled.

3. Check3 Reset the error, and then redo the printer setup.

   Press the RESUME/CANCEL button (A).

   • Redo the WPS (PIN Code) Connection

   Proceed to the link destination and continue from step 3.

   

4. Check4 Are the wireless router and printer installed in an open space where wireless communication is possible?

5. Check5 Is the wireless router operating in IEEE802.11n, IEEE802.11g or IEEE802.11b?

   • Redo the WPS (PIN Code) Connection

For details on checking the wireless router settings, see the wireless router manual or contact its manufacturer.