Cannot Communicate with the Printer After the Network Settings Are Changed
Cannot Communicate with the Printer over the Wired LAN
Cannot Print from a Computer Connected to the Network
Wait until the IP address is assigned to the computer. You may need to restart your computer.
Search for the printer again after confirming a valid IP address is assigned to the computer.
Check 1: Make sure that the printer is turned on.
Check 2: Make sure that the LAN cable is connected properly.
Make sure that the printer is connected to the router with the LAN cable. If the LAN cable is loose, connect the cable properly.
If the LAN cable is connected to the WAN side of the router, the cable is connected to the LAN side of the router.
If the problem is not resolved, insert the CD-ROM in the DVD/CD-ROM drive on your computer to start setting up again, or access our web site through the Internet and download the latest MiniMasterSetup for your model.
NoteIf you use the printer with its firmware updated, use MiniMasterSetup to perform the setup procedure.
Check 1: Make sure that the network settings of the computer are correct.
For the procedures to set up the computer, refer to the instruction manual of your computer or contact its manufacturer.
Check 2: If the printer driver is not installed, install the printer driver.
Install the printer driver with the Setup CD-ROM.
Page top |
