skip to main text

LAN settings

  • Wi-Fi

    Enables/Disables Wi-Fi.

  • Wireless Direct

    Enables/Disables Wireless Direct.

  • Wired LAN

    Enables/Disables Wired LAN.

  • Confirm LAN settings

    The LAN setting information is displayed.

  • Advanced setup

    • Set printer name

      Specifies the printer name.

      Note

      • You cannot use the same printer name as that already used for other LAN connected devices.
      • You cannot use a hyphen for the initial or last character of the printer name.
    • TCP/IP settings

      Performs IPv4 or IPv6 setting.

    • WSD settings

      Perform settings to use WSD.

    • Bonjour settings

      Perform settings to use Bonjour.

    • LPD settings

      Perform settings for printing with LPD.

    • RAW settings

      Perform settings for printing with RAW.

    • LLMNR settings

      Perform settings for printing with LLMNR.

    • SNMP settings

      Perform settings for using SNMP to manage and control the printer.

    • SNTP settings

      Perform settings for using SNTP to adjust the time on the printer.

    • FTP settings

      Perform settings for printing with FTP.

    • IPP Settings

      Perform settings for printing with IPP.

    • CHMP settings

      Perform settings for communication at the time when printer drivers or applications acquire the information on status, paper, and job log, from the printer.

      Selecting Enable HTTPS redirection redirects the communication using CHMP to encrypted communication.

      Note

    • Network interface settings

      To connect to a hub that supports spanning tree, select Spanning tree settings > Enable.

      Selecting Enable avoids circulating data on a network.

    • DRX settings

      When enabled, data is received intermittently during network connection.

    • IP filtering

      Allows or denies access for specific IP addresses.

      Settings for both IPv4 and IPv6 addresses can be specified.

      Important

      • If the device address for the administrator has been set to rejection by mistake, select LAN settings on the HOME screen of the operation panel, and then select Advanced > Reset LAN settings in this order, and initialize network information of the printer.

        After resetting, perform setup again as necessary.

    • MAC address filtering settings

      Allows or denies access for specific MAC addresses.

      Important

      • If the device address for the administrator has been set to rejection by mistake, select LAN settings on the HOME screen of the operation panel, and then select Advanced > Reset LAN settings in this order, and initialize network information of the printer.

        After resetting, perform setup again as necessary.

    • Reset LAN settings

      Initializes the network settings on the printer.

      After resetting, perform setup again as necessary.