skip to main text

Updating Printer Firmware

Important

  • Make sure the printer is connected to Internet before updating printer firmware.
  • If the firmware update is carried out, all faxes stored in the printer's memory are deleted.

  • You cannot start the firmware update under the following conditions:

    • While the printer is sending or receiving a fax
    • When the unsent faxes are stored in the printer's memory

Follow the procedure below.

Updating Printer Firmware from Operation Panel

  1. Check that printer is turned on.

    If the HOME screen is not displayed, tap the HOME button.

  2. Select (Setup) on HOME screen.

    The setup menu screen appears.

  3. Select Device settings.

  4. Select Firmware update.

  5. Select Install update.

  6. Check displayed message and select Yes.

  7. Check displayed message and select Start update.

    Important

    • If faxes are stored in the printer's memory, a message appears. Check the displayed message and select OK to continue. Tap Stop to cancel firmware update.

    Update starts.

    Finishing update turns off the printer and it turns on again.

  8. Check displayed message and select OK.

Updating Printer Firmware from Remote UI

  1. Display printer status on web browser.

  2. Select Firmware update.

  3. Select Install update.

  4. Check displayed message and select Update.

    Important

    • If faxes are stored in the printer's memory, a message appears. Check the displayed message and select Yes to continue. Select No to cancel firmware update.

    Update starts and returns to the menu screen when update is completed.