skip to main text

Example Basket Configurations

When printing line drawings on plain paper, you can use the basket not only at the regular position but also at two kinds of extended positions convenient for catching printed material.

In these extended positions, the basket can collected up to approximately 20 sheets of printed material.

The paper sizes that can be used with these extended positions are shown in the table below. Use the best position that suits the paper size and orientation.

Important

  • Use the regular position in the following situations. If you print multiple sheets in the regular position, remove the printed material from the basket one sheet at a time.

    • Paper other than plain paper
    • Paper sizes not listed in the following table and printed material other than line drawings
    • If the paper curls excessively due to the qualities of the paper or the usage environment
    • If the paper curls excessively near the end of a roll of paper

  • Return the basket to the regular position after printing.

Extended position A

Paper orientation SD-35 / SD-34 SD-26 / SD-25
Portrait

36"x48" (ARCH E) (914.4 x 1219.2 mm)

24"x36" (ARCH D) (609.6 x 914.4 mm)

A0 (841.0 x 1189.0 mm)

A1 (594.0 x 841.0 mm)

24"x36" (ARCH D) (609.6 x 914.4 mm)

A1 (594.0 x 841.0 mm)

Extended position B (SD-35 / SD-26 only)

Paper orientation SD-35 SD-26
Landscape

24"x36" (ARCH D) (609.6 x 914.4 mm)

18"x24" (ARCH C) (457.2 x 609.6 mm)

A1 (594.0 x 841.0 mm)

A2 (420.0 x 594.0 mm)

18"x24" (ARCH C) (457.2 x 609.6 mm)

A2 (420.0 x 594.0 mm)

Regular position

Illustration of the regular position

Extended position A

Illustration of the extended position A

Extended position B (SD-35 / SD-26 only)

Illustration of the extended position B

Switching to Extended position A

Switch the stacker to Extended position A as follows.

  1. Lift the Support Rod to the position shown (A) and switch the stacker to Extended position A.

  2. When using 24-inch or A1 (portrait) roll paper, pull out the Adjustable Stopper (B).

    This completes the procedure for switching to Extended position A.

Once the printing has finished, use the following procedure to return to the regular position.

  1. Lower the Support Rod to the position shown (C) to return to the regular position.

    If the Adjustable Stopper (B) is extended, retract it.

  2. Return to the regular position.

Switching to Extended position B (SD-35 / SD-26 only)

Switch the stacker to Extended position B as follows.

  1. Grasp the basket handle (A) and pull out the basket so that it tilts towards you.

  2. Open the Basket Ejection Guides (B).

    This completes the procedure of switching to Extended position B.

Once the printing has finished, use the following procedure to return to the regular position.

  1. Push the Basket Ejection Guides (B) closed until it clicks into place.

  2. Hold onto the basket handle (A) and pull the basket release lever (C) towards you.

  3. While continuing to hold the basket handle (A), slowly lower the basket.

  4. Return to the regular position.