Setting Password

Each of passwords for administrator and standard user can be set.

When logging on with password for administrator, all settings can be changed.

When logging on with password for standard user, some of the settings can be changed.

When logging on with password for administrator, you can restrict the function for standard user.

Note

Setting Administrator Password

Change the administrator password by following the steps below.

Important

The password of printer is set at the time of purchase.
- Default Administrator Password

Display printer status on web browser.
Select Security.

The menus are displayed.
Select Administrator password setting.
Select Change administrator password.

If the administrator password is not set, registration confirming message is displayed. Select Yes. When message is displayed again, select OK.
Select a range where the administrator password is valid, and then select OK.

Remote UI or other tools

Entering the administrator password is required to change the setting items using the Remote UI or IJ Network Device Setup Utility.

LCD, Remote UI, or other tools

Entering the administrator password is required to change the setting items using the operation panel of the printer, the Remote UI, or IJ Network Device Setup Utility.
Enter a password, and then select OK.

Important
- The following character restrictions apply to the password:
  - Set the password by using 4 to 32 characters.
  - The allowed characters are single-byte alphanumeric characters, blank space, umlaut characters, and the below symbols.
    
    - ! @ # $ % ^ & * _ ; : , . / ` = + ' " ( ) [ ] { } < > |
  - For security reasons, we recommend you use 8 and more alphanumeric characters.
When the completion message is displayed, select OK.

Enable the standard user mode and set a standard user password by following the steps below.