The edges of the paper are dirty

1. Check 1 Was printing borderless or on small paper?

   The platen may become dirtied by borderless printing or on small paper sizes.

   Open the top cover and clean the platen.

   • Cleaning Inside the Top Cover

2. Check 2 Is Extension for borderless printing set to a large value?

   The platen may become dirtied by setting a large amount of extension.

   Reduce the value of Extension for borderless printing.

   • Specifying the Amount of Extension for Borderless Printing

3. Check 3 Is the media type specified in the printer driver the same as the media type in the printer?

   When printing with the media type specified in the printer driver, load the specified media type in the printer.

   • Loading the Upper Roll on the Printer
   • Loading the Lower Roll on the Roll Unit (Option)
   • Loading Sheets in the Printer

   When printing with the media type loaded in the printer, specify the same media type in the printer driver.

   1. To stop printing, tap the Stop.

   2. Change the type of paper in the printer driver and try printing again.

   Note

   • When Auto (Use Printer Settings) is selected for the media type, printing is performed with the media type loaded in the printer.

   • Click Get Information to reflect the paper information set in the printer to the printer driver.

     • Printing with Easy Setup

4. Check 4 When loading paper in the printer, is the media loaded the same as the media type selected on the touch screen?

   Select the correct media type in the touch screen menu when loading paper in the printer.

   • Loading the Upper Roll on the Printer
   • Loading the Lower Roll on the Roll Unit (Option)
   • Loading Sheets in the Printer

5. Check 5 Is the paper creased or curled?

   Straighten out the wrinkles or curls and reload the paper.

   • Loading the Upper Roll on the Printer
   • Loading the Lower Roll on the Roll Unit (Option)
   • Loading Sheets in the Printer

6. Check 6 Is Cut-dust reduction in the touch screen menu Advanced paper settings set to ON?

   A cut dust reduction line is printed at the paper cut position when Cut-dust reduction is set to ON.

   If cutting dust reduction is not required, set Cut-dust reduction to OFF.

   • Menu Structure

7. Check 7 Is the Print head height set too low in the touch screen menu?

   Set Head height to the value higher than the current one.

   • Troubleshooting Paper Abrasion and Blurry Images

8. Check 8 Is the paper thick, or a type that curls easily or is prone to buckling after absorbing ink?

   If using paper-based printing material such as thick-coat paper, set Transport unit vacuum strength in the touch screen menu to Medium-strong or Strong.

   If that does not resolve the problem, increase the Head height setting in the touch screen menu.

   • Adjusting Vacuum Strength
   • Troubleshooting Paper Abrasion and Blurry Images

   If using film-based printing material such as tracing paper, set the Transport unit vacuum strength in the touch screen menu to Standard, Medium-strong, or Strong.

   If that does not resolve the problem, increase the Head height setting in the touch screen menu.

   • Adjusting Vacuum Strength
   • Troubleshooting Paper Abrasion and Blurry Images

9. Check 9 Is the output guide clean?

   Clean the output guide.

   • Cleaning the Printer Exterior