skip to main text

Paper rubs against the Print Head

  1. Check 1 Is the media type specified in the printer driver the same as the media type loaded in the printer?

    When printing with the media type specified in the printer driver, load the specified media type in the printer.

    When printing with the media type loaded in the printer, specify the same media type in the printer driver.

    1. To stop printing, tap the Stop.

    2. Change the paper type in the printer driver and try printing again.

    Note

    • When Auto (Use Printer Settings) is selected for the media type, printing is performed with the media type loaded in the printer.

    • Click Get Information to reflect the paper information set in the printer to the printer driver.

  2. Check 2 When loading paper in the printer, is the media loaded the same as the media type selected on the touch screen?

    Select the correct media type in the touch screen menu when loading paper in the printer.

  3. Check 3 Is the paper loaded properly?

    If not loaded properly, paper can buckle and rub against the Print head.

    Reload the paper.

  4. Check 4 Is the Print head height set too low?

    Set Head height in the touch screen menu to the value higher than the current one.

  5. Check 5 Is the paper thick, or a type that curls easily or is prone to buckling after absorbing ink?

    If using paper-based printing material such as Heavyweight Coated Paper, set Transport unit vacuum strength in the touch screen menu to Medium-strong or Strong.

    If that does not resolve the problem, increase the Head height setting in the touch screen menu.

    If using film-based printing material such as CAD Tracing Paper, set the Transport unit vacuum strength in the touch screen menu to Standard, Medium-strong, or Strong.

    If that does not resolve the problem, increase the Head height setting in the touch screen menu.

    If using paper thinner than 0.004 inches (0.1 mm), set Transport unit vacuum strength in the touch screen menu to Weak.

    If that does not resolve the problem, increase the Head height setting in the touch screen menu.

  6. Check 6 Does the paper have a strong curl at the front edge or is it buckled?

    Set Cutting mode in the touch screen menu to User cut, and set leading edge detection to Do not detect.

    To keep track of the amount of roll paper remaining, set Manage remaining roll amount to Auto estimate or Disable before loading the roll paper, and then restore the setting of Manage remaining roll amount to Auto estimate or Barcodes after the roll paper is loaded.

    In addition, set Media type selection method to Manual or Use current media type.