Banding in different colors occurs
- Check 1
Are paper actually loaded on the printer and the media type selected on the touch screen the same?
Select the correct media type in the touch screen menu when loading paper in the printer.
- Check 2
Has the paper feed rate been calibrated properly?
Adjust the feed amount.
- Check 3
Print job may have been interrupted while receiving, and therefore not printed at a fast frame rate
Exit other applications and cancel other print jobs.
- Check 4
Is Set priority in the touch screen menu set to Prioritize length accuracy?
Setting Set priority to Prioritize print quality and adjusting the feed amount can help.
- Check 5
Check if the print head is in the right position
Adjust the print head position.
- Check 6
Make sure that the print head nozzle is not blocked
Print a test pattern to check the nozzles and see if they are clogged.
Note
-
To automatically check for nozzle blockages after printing, set Auto nozzle check in the touch screen menu to a setting other than Disable.
To show warnings based on nozzle check results, set Nozzle check error display in the touch screen menu to Enable.
However, printing may be stopped by warnings if this setting is set to Enable.
-
- Check 7
Low Print Quality setting causing lines in the printing
Follow the steps below to set Print Quality to Highest or High, and then print.
- Windows
Change the Print Quality settings in the printer driver Advanced Settings.
Changing the Print Quality and Correcting Image Data (Windows)
- Mac OS
Change the Print Quality in the printer driver Quality & Media settings.
Changing the Print Quality and Correcting Image Data (Mac OS)
When Fast or Standard is selected, the printing time is shorter and less ink is used than with Highest or High, but the print quality is reduced.
- Windows
- Check 8
Is the media type specified in the printer driver the same as the media type loaded in the printer?
Load paper of the same type as you have specified in the printer driver.
Loading the Upper Roll on the Printer
Loading the Lower Roll on the Roll Unit (Option)
Follow the steps below to change the printer driver settings.
-
To stop printing, press the Stop button.
-
Change the type of paper in the printer driver and try printing again.
-
- Check 9
Check whether the banding occurs within 100mm of the leading edge of the paper.
If paper is set on the printer for a long time before printing, the paper may curl resulting in banding.
To avoid this, set Energy save mode paper rewind to Enable from Paper-related settings, and set the Sleep timer in Energy saving settings to a shorter time. Paper will be moved to a position where it will not curl.
Important
-
Energy save mode paper rewind is only available with firmwave version 2.0.0 and above. Please update your firmware if using an earlier verison.
-