skip to main text

Setting Up - Connecting Phone Line

Make a line connection and various settings for using the fax functions.

  1. Make sure the printer is turned on.

  2. Tap FAX.

    If FAX is not displayed, select HOME (HOME).

    HOME screen: Select FAX

    Easy setup starts.

  3. Tap Start Easy setup.

    Easy setup screen: Make settings for sending/receiving FAX
  4. Tap Next.

    Easy setup screen: Easy setup guides you through the following procedures.
  5. Connect the supplied phone cord to the printer's jack (labeled LINE on the back).

    Easy setup screen: Connect one end of the supplied phone cord to the LINE jack on the rear side of the device.
    figure: Phone cord connection (printer)

    Note

    • For users in the United Kingdom:

      If the connector of the external device cannot be connected to the jack on the printer, you will need to purchase a B.T. adapter to connect as follows:

      Attach the B.T. adapter to the phone cord connecting the external device, and then connect the B.T. adapter to the external device jack.

  6. Tap Next.

    Easy setup screen: Select Next
  7. Connect the other end of the phone cord to an xDSL modem or a splitter.

    Easy setup screen: Connect the other end of the phone cord to your TEL line socket, modem or splitter.

    <Connection example>

    xDSL modem with built-in splitter

    figure: Phone cord connection example (xDSL line: modem with built-in splitter)

    Splitter + xDSL modem

    figure: Phone cord connection example (xDSL line: external splitter)
  8. Tap Next.

    Easy setup screen: Select Next
  9. Tap Next since you will not connect a telephone to the printer.

    Easy setup screen: Select Next
  10. Tap Start to perform a connection test for checking if the telephone line is connected correctly.

    Easy setup screen: Start the telephone line connection test.

    If none of the above measures solve the problem, the printer may be defective, or the problem may be caused by some other reason.

    As we need to check the detailed status, please contact your nearest Canon service center.

  11. Tap No (FAX only).

    Easy setup screen: Select No (FAX only)
  12. Check the specified settings, and then tap OK.

    Easy setup screen: Check FAX settings
  13. Check if you hear beeps/boops (signal tones) when you dial from your telephone.

    If you do not hear signal tones, set pulse dialing.

The phone line connection is completed.

Next, set the sender information and the date and time. Go to the next page.