skip to main text

Setting Up - Connecting Phone Line

Make a line connection and various settings for using the fax functions.

  1. Make sure the printer is turned on.

  2. Use the Up Down buttons to select Fax.

    If Fax is not displayed, press the HOME button.

  3. Press the OK button.

    Easy setup starts.

  4. Make sure Start setup is selected, and then press the OK button.

  5. Connect the supplied phone cord to the printer's jack (labeled LINE on the back).

    figure: Phone cord connection (printer)

    Note

    • For users in the United Kingdom:

      If the connector of the external device cannot be connected to the jack on the printer, you will need to purchase a B.T. adapter to connect as follows:

      Attach the B.T. adapter to the phone cord connecting the external device, and then connect the B.T. adapter to the external device jack.

  6. Connect the other end of the phone cord to an xDSL modem or a splitter.

    <Connection example>

    xDSL modem with built-in splitter

    figure: Phone cord connection example (xDSL line: modem with built-in splitter)

    Splitter + xDSL modem

    figure: Phone cord connection example (xDSL line: external splitter)
  7. Press the OK button.

  8. Remove the cap from the printer's jack (labeled EXT. on the back), and then connect the printer and the telephone with a phone cord.

    figure: Telephone connection

    Note

    • If you have only one phone line contract, parallel connection of a telephone and fax machine to different wall jacks (branch connection) is not possible.

      figure: Branch connection
  9. Press the OK button.

  10. Press the OK button to perform a connection test for checking if the telephone line is connected correctly.

    If none of the above measures solve the problem, the printer may be defective, or the problem may be caused by some other reason.

    As we need to check the detailed status, please contact your nearest Canon service center.

  11. Make sure Sharing fax/telephone is selected, and then press the OK button.

  12. Press the OK button.

  13. Check the specified settings, and then press the OK button.

  14. Check if you hear beeps/boops (signal tones) when you dial from your telephone.

    If you do not hear signal tones, set pulse dialing.

The phone line connection is completed.

Next, set the sender information and the date and time. Go to the next page.