Troubleshooting -WPS (PIN code)-
Select an applicable item.
"Failed to connect <See manual>" is Displayed
The screen appears when an error occurs.
Check the access point settings, then configure WPS settings again.
For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer.
"PIN codes do not match <See manual>" is Displayed
The screen appears when WPS setup was not completed within a specified time.
Perform the setup again and set the new PIN code displayed on the screen to the access point.
- Is the network device (router, etc.) turned on? If the network device is already turned on, turn it off, then turn it back on.
Do not operate the screen of this guide until the power is on. The connection to the network device will be temporarily disabled.
"Timeout error <See manual>" is Displayed
The screen appears when WPS setup was not completed within a specified time.
Perform the setup again and set the new PIN code displayed on the screen to the access point.
- Is the network device (router, etc.) turned on? If the network device is already turned on, turn it off, then turn it back on.
Do not operate the screen of this guide until the power is on. The connection to the network device will be temporarily disabled.
