skip to main text

Troubleshooting -Manual connect-

"The directly entered wireless router was not detected." Appears

  1. Check1 Is the wireless router turned on?

    If it is already turned on, turn it off, and then turn it back on.

    Do not proceed to the next screen of this guide until the power is turned on. The connection to the wireless router will be temporarily disabled.

    Tap OK to confirm that the wireless router name (SSID) is correct, and then tap OK again.

 

If the wireless router is still not detected

  1. Check2 Is the entered wireless router name (SSID) correct?

  2. Check3 Are the wireless router and printer installed in an open space where wireless communication is possible?

  3. Check4 Is the wireless router operating in IEEE802.11n, IEEE802.11g or IEEE802.11b?

    Tap OK to confirm that the wireless router name (SSID) is correct, and then tap OK again.

  4. Check5 Check the wireless router's settings.

    If SSID broadcast (e.g., "ANY" connection) is disabled or the stealth mode is enabled on the wireless router, enable SSID broadcast or disable the stealth mode, and then tap OK to search for the wireless router again.

  5. Check6 Check the wireless router's security protocol (encryption method) settings.

    If "WPA/WPA2 Enterprise" is set, change it to "WPA/WPA2" on the wireless router. This printer does not support "WPA/WPA2 Enterprise."

    For details on changing the security protocol (encryption standard) used by the wireless router, see the wireless router manual or contact its manufacturer.