Troubleshooting -WEP-

"Failed to connect to the access point." is Displayed

Make sure that the entered WEP key for the access point and selected WEP key number are correct, then set up a wireless connection again.

• To enter the access point name directly again, tap OK and see here

To change the WEP key number you want to use, change the access point settings, then set up a wireless connection again.

• To enter the access point name directly again, tap OK and see here

For details on how to change the WEP key number of the access point, refer to the manual supplied with the access point or contact its manufacturer.

When there is no problem with the WEP key and WEP key number

If the DHCP function of the access point is inactive, enable the DHCP function and configure wireless connection settings again.

• To enter the access point name directly again, tap OK and see here

When the DHCP function is active

If using an access point that automatically creates WEP keys, check the WEP key (hexadecimal) created automatically on the access point, then enter it on the printer.

• To enter the access point name directly again, tap OK and see here

For details on how to check or change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer.

When there is no problem with WEP key

If the MAC address filtering is enabled on the access point, change settings so that the MAC address of the printer will be accepted.

Follow the procedure below to check the MAC address of the printer.

1. Touch the HOME button.
2. Tap Setup.
3. Tap Device settings.
4. Tap LAN settings > Confirm LAN settings > WLAN setting list to check MAC address.
   

• To enter the access point name directly again, tap OK and see here

When the MAC address filtering is disabled on the access point, set up a wireless connection again.

• To enter the access point name directly again, tap OK and see here

For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer.

"The device may not be able to connect to the network." is Displayed

Tap OK.

If the DHCP function of the access point is inactive, enable the DHCP function or specify the IP address (IPv4 only) of the printer and configure wireless connection settings again. In addition, make sure that the selected WEP key number and entered WEP key are correct.

When specifying the IP address of the printer

To specify the IP address of the printer, follow the procedure below.

1. Tap Setup in the HOME screen.
2. Tap Device settings.
3. Tap LAN settings.
4. Tap Other setup.
5. Tap TCP/IP settings.
6. Tap IPv4.
7. Tap Yes.
8. Tap IP address.
9. Tap Manual setup.

Follow the on-screen instructions to proceed with settings.

When the setup is complete, touch the HOME button, then set up a wireless connection again.

• Enter the access point name directly again

When the DHCP function is active

Enter wireless connection settings of the access point directly.

• Enter the access point name directly again

When there is no problem with the WEP key number and WEP key

• Enter the access point name directly again

For details on how to check or change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer.