Troubleshooting -WPS (PIN code)-

"Failed to connect." is Displayed

The screen appears when an error occurs.

Check the access point settings, then configure WPS settings again.

• To configure WPS settings again, press the OK button and see here

• To set up a wireless connection manually, press the OK button and see here

(Proceed to the guide for Standard setup)

For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer.

The Timeout Error Screen is Displayed

The screen appears when WPS setup was not completed within a specified time.

Perform the setup again and set the new PIN code displayed on the screen to the access point.

• Is the network device (router, etc.) turned on? If the network device is already turned on, turn it off, then turn it back on.

Do not operate the screen of this guide until the power is on. The connection to the network device will be temporarily disabled.

• To configure WPS settings again, press the OK button and see here

"Cannot connect with WPS." is Displayed

The screen appears when WPS setup was not completed. Set up manually.

• To set up manually, press the OK button and see here

(Proceed to the guide for Standard setup)