Changing the Machine Operation Mode

The machine can increase the gap between the print head and the paper during high-density printing to prevent paper abrasion.
Check this check box to prevent paper abrasion.

Usually, the Print Head Alignment function on the Maintenance tab is set to automatic head alignment, but you can change it to manual head alignment.
If the printing results are unsatisfactory even after you execute automatic head alignment, see "Aligning the Print Head Position from Your Computer," and execute manual head alignment.
Check this check box to perform the manual head alignment. Uncheck this check box to perform the automatic head alignment.

Select this check box only if the machine is feeding multiple sheets of plain paper at the same time.

Important

• Using this function slows down the print speed.

On the Page Setup tab, you can change the rotation direction of the Landscape in the Orientation.
To rotate the print data 90 degrees to the left during printing, select this item. To rotate the print data 90 degrees to the right during printing, clear this item.

Important

• Do not change this setting while the print job is displayed in the print wait list. Otherwise, characters may be omitted or the layout may become corrupt.

You can set the length of the machine rest time until printing of the next page begins. Moving the slider to the right increases the pause time, and moving the slider to the left decreases the time.
If the paper gets stained because the next page is ejected before the ink on the printed page dries, increase the ink drying wait time.
Reducing the ink drying wait time speeds up printing.