skip to main text

Adjusting Print Head Position Automatically

Any error in the print head installation position can cause color and line shifts. Adjusting the print head position improves print results.

Print head position can be adjusted either automatically or manually. Normally, the printer is set up to perform automatic head position adjustment. However, if notice that lines are shifted or are otherwise not satisfied with the print results even after performing automatic head position adjustment, adjust the print head position manually.

This section describes the procedure for adjusting the head position automatically.

Print Head Alignment

  1. Open printer driver's setup screen

  2. On Maintenance tab, click Print Head Alignment

    The Start Print Head Alignment dialog box appears.

  3. Load paper in printer

    In the rear tray, load 1 sheet of plain A4-sized or Letter-sized paper.

    Note

    • If you select manual head position adjustment, the number of sheets to use will differ.

  4. Print head position adjustment patterns

    Check that the printer power is on, and then click Align Print Head.
    The adjustment patterns are printed.

    Important

    • While the printer is printing, do not open the printer scanning unit / cover.

  5. Scan adjustment patterns

    When adjustment pattern printing is completed, a message appears.
    Following these instructions place the adjustment patterns on the platen, and press the printer's Start button.
    Head position adjustment starts.

Note

  • In the Start Print Head Alignment dialog box, click Print Alignment Value to print the current settings so that you can check the settings.