Page Processing
You can configure advanced settings, such as for printing on roll paper and for adjusting how much of the document extends outside the paper when printing borderless.
- Roll Paper Width
-
Select the roll paper width.
Select the width that matches the width of the roll paper loaded in the printer. - Width
- This enables you to select Custom Size in Roll Paper Width, allowing you to specify the roll width.
- Three-sided Borderless
- If you check this check box, and the width or the length of the output paper size is smaller than the roll width, a margin will be created on the right of the document, and the remaining three sides (top, bottom, and left) will be borderless when printing.
- Banner Printing
- Select this check box to print documents with several pages as one continuous document. When you do this, the spaces between the pages will be removed.
- Fit Roll Paper Width
-
The printer automatically expands or reduces the document to match the roll paper width and then prints the document.
- Off
- The document is printed as-is without being expanded or reduced.
- On (Bordered)
- The printer automatically expands or reduces the document to match the roll paper width and then prints the document.
- On (Borderless)
- When borderless printing is performed, the printer automatically enlarges or reduces the document to match the roll paper width and then prints the document.
- No Spaces at Top or Bottom
- When printing on roll paper, you can save paper by reducing the upper and lower margins.
- Rotate Page 90 degrees
- When you print a portrait document onto roll paper, you can save paper by rotating the document 90 degrees and print the document horizontally relative to the paper.
- Borderless Extension
-
Adjusts how much of the document extends outside the paper by using the Borderless Extension slider bar.
Drag to slider bar to the right to increase the extension amount, and to the left to decrease the extension amount. - Print Centered
- Prints document in center of paper.
Note
- Depending on the settings, some items cannot be set.