skip to main text

Paper Detailed Settings

Use this dialog box to set detailed print settings that match the media type loaded on the printer.

If the paper becomes stained during printing or if the quality of the print results is less than expected, using these settings may improve the print results.

figure:Paper Detailed Settings in the Print dialog
Dry Time (Between Pages)
Allows you to set the interval between the time each page is printed and the time it exits the printer. Since a certain waiting time is required for the ink to dry before the roll paper is cut, even when, on Paper Detailed Settings, Automatic Cutting is set to Yes, you can let the document fall into the basket with the ink dried.
The Dry Time (Between Pages) setting is effective only for roll paper.
Printer Default
Applies the settings configured in operation panel of the printer.
None
Documents are ejected immediately after printing is over.
30 seconds / 1 minute / 3 minutes / 5 minutes / 10 minutes / 30 minutes / 60 minutes
After printing is over, documents are ejected after the set time has elapsed.
Dry Time (Between Scans)
Allows you to set the interval between the printing of a scan on a page and the printing of the next scan. Prevents ink bleeding on a page or uneven coloring during borderless printing.
Printer Default
Applies the settings configured in operation panel of the printer.
None
Each scan is printed immediately after the previous one.
0.5 seconds / 1 second / 3 seconds / 5 seconds / 7 seconds / 9 seconds
After one scan has been printed, the next one will be printed after the set time has elapsed.
Increase the interval depending on the occurrence of bleeding and uneven coloring.
Roll Paper Safety Margin
Allows you to specify the length of the white margins on the edges of the paper in order to make even significantly curled paper adsorb to the platen.
Printer Default
Applies the settings configured in operation panel of the printer.
3mm
Prints in standard-size.
Choose this setting if there are no particular problems when printing.
20mm
Choose this setting in case of chafing against the print head, for example when using significantly curled paper.
Cut Speed
Allows you to select the speed of automatic cutting. Use it to adjust the automatic cutting function when clean cutting is not possible.
Printer Default
Applies the settings configured in operation panel of the printer.
Fast
Choose this if clean cut surfaces are not possible with the Standard setting.
Standard
Choose this if there are no particular problems with automatic cutting.
Slow
Choose it when using adhesive paper in order to prevent the glue from sticking to the cutter and to avoid a drop in cutting performance.
Automatic Cutting
You can set whether to have the paper cut automatically or to have cut lines printed on the paper.
The following settings can be configured for automatic cutting.
Printer Default
Applies the settings configured in the operation panel of the printer unit.
None
After printing is over, the printer goes on to print the next set of data without cutting the paper into individual pages.
Print Cut Guideline
After printing is over, the printer prints cutting lines on each page and goes on to print the next set of data.
Unidirectional Printing
Suppresses uneven coloring and line shifts during printing.
To perform unidirectional printing, check this check box.
Calibration Value
Allows you to apply the results of calibration performed on the printer. To apply the calibration values, select Use Value.