Edit Accessible IP Address Screen/Add Accessible IP Address Screen

Note

• This function is not available depending on the printer you are using.

The example screenshots in this section refer to the Add Accessible IP Address Screen.

1. Specification Method:

   Select either Single Address Specification or Range Specification to add the IP address(es).

   Single Address Specification

   Specify each IP address separately.

   Range Specification

   Specify a range of successive IP addresses.

2. IP Address:

   Enter the IP address of a computer or a network device to allow access when you selected Single Address Specification in Specification Method:.

   An IP address is expressed as four values ranging from 0 to 255.

   Start IP Address:

   Enter the first IP address in the range of addresses of the computers or network devices to allow access when you selected Range Specification in Specification Method:.

   An IP address is expressed as four values ranging from 0 to 255.

   End IP Address:

   Enter the last IP address in the range of addresses of the computers or network devices to allow access when you selected Range Specification in Specification Method:.

   An IP address is expressed as four values ranging from 0 to 255.

   Note

   • The Start IP Address: must be a smaller value than the End IP Address:.

3. Comment:

   Optionally enter any information to identify the device, such as the name of the computer.

   Important

   • Comments will be displayed only on the computer used to enter them.