Changing the WEP Detailed Settings

Note

  • This screen is not available depending on the printer you are using.

To change the wireless network settings of the printer, connect the printer and the computer with a USB cable temporarily. If you modify the wireless network settings of the computer over wireless connection without USB connection, your computer may not be able to communicate with the machine after modifying the settings.

  1. Start up IJ Network Tool.

  2. Select the printer in Printers:.

    When the printer is connected to the computer with a USB cable temporarily, select the printer with "USBnnn" (where "n" is a number) appearing in the Port Name column.

  3. Select Configuration... from the Settings menu.

  4. Click the Wireless LAN tab.

  5. Select Use WEP in Encryption Method: and click Configuration....

    The WEP Details screen is displayed.

  6. Change the settings or confirm.

    When changing the password (WEP key), the same change must be made to the password (WEP key) of the access point.

    figure: WEP Details screen

    1. WEP Key:

      Enter the same key as the one set to the access point.

      The number of characters and character type that can be entered differ depending on the key length and key format.

       

      Key Length

      64bit

      128bit

      Key Format

      ASCII

      5 characters

      13 characters

      Hexadecimal (Hex)

      10 digits

      26 digits

    2. Key Length:

      Select either 64bit or 128bit.

    3. Key Format:

      Select either ASCII or Hex.

    4. Key ID:

      Select the Key ID (index) set to the access point.

    5. Authentication:

      Select the authentication method to authenticate the printer's access to the access point.

      Normally, select Auto. If you want to specify the method manually, select Open System or Shared Key according to the setting of the access point.

  7. Click OK.

    Important

    • If the printer cannot communicate with the computer after the encryption type of the printer was switched, make sure that encryption types for the computer and the access point matches that set to the printer.

    Note

    • Changing the network settings with the USB cable temporarily may switch the default printer. In this case, reset Set as Default Printer.