Home

Click Here to Search

NW029W

Edit Accessible IP Address Screen/Add Accessible IP Address Screen

Note

  • This screen is not available depending on the printer you are using.

The example screenshots in this section refer to the Add Accessible IP Address Screen.

figure: Add Accessible IP Address screen

  1. Specification Method:

    Select either Single Address Specification or Range Specification to add the IP address(es).

    Single Address Specification

    Specify each IP address separately.

    Range Specification

    Specify a range of successive IP addresses.

  2. IP Address:

    Enter the IP address of a computer or a network device to allow access when you selected Single Address Specification in Specification Method:.

    An IP address is expressed as four values ranging from 0 to 255.

    Start IP Address:

    Enter the first IP address in the range of addresses of the computers or network devices to allow access when you selected Range Specification in Specification Method:.

    An IP address is expressed as four values ranging from 0 to 255.

    End IP Address:

    Enter the last IP address in the range of addresses of the computers or network devices to allow access when you selected Range Specification in Specification Method:.

    An IP address is expressed as four values ranging from 0 to 255.

    Note

    • The Start IP Address: must be a smaller value than the End IP Address:.

  3. Comment:

    Optionally enter any information to identify the device, such as the name of the computer.

    Important

    • Comments will be displayed only on the computer used to enter them.

Page top