WEP Details / WPA Details / WPA2 Details / WPA/WPA2 Details

WEP Details

Important

• Always set up the printer first. If you set the WEP key in the access point without setting the WEP key in the printer, communication may be disabled. For information on how to set the WEP key in the access point, see the user's guide that comes with the access point.

[WEP Key]

Enter the same WEP key that was set in the access point.
The number of characters and character type that can be entered will differ depending on the combination of the key length and key format.

		Key length
		64 bits	128 bits
Key format	ASCII	5 characters	13 characters
	Hex	10 digits	26 digits

[Key Length]

Select either [64 bits] or [128 bits].

[Key Format]

Select either [ASCII] or [Hex].

[Key ID]

Specify the transmission WEP key that has been set in the access point. Also select the number that was set to that WEP key in the access point.

[Authentication]

Authentication is executed so that the printer can communicate with the access point.
Normally, select [Auto].
You can also select [Open System] or [Shared Key] depending on the setting for the access point.

[OK]

Sets WEP according to the specified information.

[Cancel]

Cancels the setup.
Since the setup has not been completed, you must execute the setup again to use the printer.

WPA Details

[Passphrase]

Enter the passphrase.

[Dynamic Encryption Type]

Select the dynamic encryption type.

[OK]

Sets WPA according to the specified information.

[Cancel]

Closes this screen.

WPA2 Details

[Passphrase]

Enter the passphrase.

[Dynamic Encryption Type]

Select the dynamic encryption type.

[OK]

Sets WPA2 according to the specified information.

[Cancel]

Closes this screen.

WPA/WPA2 Details

[Passphrase]

Enter the passphrase.

[Dynamic Encryption Type]

Select the dynamic encryption type automatically.

[OK]

Sets WPA or WPA2 according to the specified information.

[Cancel]

Closes this screen.