Loading Envelopes

You can load Envelope DL and Envelope Com 10.

The address is automatically rotated and printed according to the envelope's direction by specifying with the printer driver properly.

1. Prepare envelopes.

 Press down on all four corners and edges of the envelopes to flatten them.

 If the envelopes are curled, hold the opposite corners and gently twist them in the opposite direction.

 If the corner of the envelope flap is folded, flatten it.

 Use a pen to press the leading edge in the inserting direction flat and sharpen the crease.

The figures above show a side view of the leading edge of the envelope.

2. Load envelopes.

(1) Open the front tray gently.

(2) Hold the right tab on the front tray to pull out the feeder until it stops.

(3) Use the right paper guide (A) to slide both paper guides all the way out.

(4) Load the envelopes in the center of the feeder WITH THE ADDRESS SIDE FACING DOWN.

The folded flap of the envelope will be faced up on the left side.

(B) Rear side

(C) Address side

Push the envelopes all the way to the back of the feeder.

Up to 5 envelopes can be loaded at once.

(5) Slide the right paper guide (A) to align the paper guides with both sides of the envelopes.

Do not slide the paper guides too hard against the envelopes. The envelopes may not be fed properly.

(6) Holding the right tab on the front tray, push the feeder back until the arrow () on the front tray is aligned with the arrow () on the machine.

3. Open the paper output tray.

(1) Extend the paper support (F), then open the output tray extension (G).

(2) Open the paper output tray (H) gently, then extend the paper output support (I).