skip to main text

Checking the Ink Status with the Ink Lamps

  1. Make sure that the power is turned on, and open the paper output tray gently.

  2. Open the top cover, then press the RESUME/CANCEL button.

  3. Check the ink lamp.

    Close the top cover after checking the ink lamp status.

    • The ink lamp is on.

      The ink tank is correctly installed.

    • The ink lamp is flashing.

      Flashing slowly (at around 3-second intervals)

      ...... Repeats

      Ink tank is running low. Prepare a new ink tank.

      Note

      • When printing on A3 size or larger paper, ink may run out during printing. This may cause blurred print results or horizontal white streaks.

      Flashing fast (at around 1-second intervals)

      ...... Repeats

      - The ink tank is installed in the wrong position.

      Or

      - Printer detected ink out condition.

      Make sure that the ink tank is installed in the correct position as indicated by the label on the print head holder. If the position is correct but the lamp flashes, there has been an error and the printer cannot print. Check the Alarm lamp on the printer.

    • The ink lamp is off.

      The ink tank is not installed properly or the function for detecting the remaining ink level is disabled. If the ink tank is not firmly in place, make sure that the orange protective cap has been removed from the bottom of the ink tank, then press on the top of the ink tank until the ink tank clicks into place.

      If the ink lamp is still off after reinstalling the ink tank, there has been an error and the printer cannot print. Check the Alarm lamp on the printer.

    Note