If the paper feed rollers are dirty or paper powder is attached to it, paper may not be fed properly.
In this case, clean the paper feed rollers. Cleaning will wear out the paper feed rollers, so perform this only when necessary.
You need to prepare: a sheet of A4 or Letter-sized plain paper or cleaning sheet available on the market
Make sure that the power is turned on and remove any paper from the rear tray.
Clean the paper feed rollers without paper.
(1) Hold down the Stop button until the Alarm lamp flashes orange seven times, then release it immediately.
The paper feed rollers will rotate as it is cleaned.
Clean the paper feed rollers with paper.
(1) Make sure that the paper feed rollers have stopped rotating, load a sheet of A4 or Letter-sized plain paper or cleaning sheet available on the market in the rear tray.
(2) Pull out the paper output tray and the output tray extension.
(3) Hold down the Stop button until the Alarm lamp flashes orange seven times, then release it immediately.
The machine starts cleaning. The cleaning will be complete when the paper is ejected.
If the problem is not resolved after cleaning the paper feed rollers (A) in the rear tray, turn off the power, unplug the power cord, then wipe the paper feed rollers (the center roller and the right roller) located inside the rear tray with a moistened cotton swab or the like while rotating them manually. Do not touch the rollers with your fingers. Rotate the rollers two or more times.
After cleaning the paper feed rollers, turn on the power, then clean the paper feed rollers again.
If the problem is not resolved after cleaning the paper feed rollers, contact the service center.
Page top |
