UG106M

Two-Sided Copying

When you select 2-sided for 2-sidedPrintSetting in Standard copy, you can copy two original pages onto the both sides of a single sheet of paper.

In addition, when you select Duplex for ADF duplex scan, you can perform duplex scanning.

figure: LCD

Specify the place to load originals or copy settings according to the two-sided copying method.

After selecting the stapling side and press the OK button, you can select whether you use the preview screen. If you select ON, the preview screen is displayed so that you can check the orientation.

Note
  • If Device memory is full. Cannot continue process. appears on the LCD when scanning, set the print quality to Standard, then try copying again. If the problem is not resolved, set the print quality to Fast and try copying again.

  • Two-sided copy setting can be used in combination with 2-on-1 copy or 4-on-1 copy when Standard copy is selected. In addition, two-sided copy is also available when ON is selected for Collate.

    Copying Two Pages to Fit onto a Single Page

    Copying Four Pages to Fit onto a Single Page

    Collated Copying

  • If you are copying in black & white, print intensity of the Two-sided copy may differ from that of a single-sided copy.

When Loading the Original on the platen glass:

  • Before scanning:

    When you select 2-sided for 2-sidedPrintSetting and the preview function is activated, the machine starts pre-scanning before scanning the original. When pre-scanning is finished, the screen below (preview screen) is displayed on the LCD.

    figure: LCD
    1. Rotate

      If you press the right Function button, the original rotates by 180 degrees.

    2. Rescan

      If you press the left Function button, the original is rescanned.

    Press the OK button to start scanning.

  • After scanning:

    Placing documents (platen) screen appears on the LCD after scanning each sheet of original.

    figure: LCD

    Remove the sheet of original from the platen glass after scanning and load the next sheet on the platen glass, then press the OK button.

    Note
Page top