UG130M

Setting Items on the Operation Panel of the Machine

You can change the scan settings such as the scan size, resolution, or data format.

When the Scan standby screen is displayed, press the right Function button to select the setting item. Use the UPDOWN button to select the setting item, use the LEFTRIGHT button to specify the setting, then press the OK button.

Note
  • The scan setting cannot be specified under the following conditions:

    • When Auto scan is selected for Doc.type to forward the scanned data to the computer (except for ADF orientation)

    • When you forward the scanned data to the computer using WSD (one of the network protocols supported in Windows 7 and Windows Vista)

  • Depending on the destination, some setting items cannot be selected. This section describes the setting items when you select USB flash drive on the screen for selecting to which you save the data.

    The setting item which cannot be selected is displayed grayed out.

  • Some settings cannot be specified in combination with the setting of other setting item, the document type selected for Doc.type, or the scan menu on the screen for selecting to which you save the data. If the setting which cannot be specified in combination is selected, Error details is displayed on the LCD. In this case, press the left Function button to confirm the message, then change the setting.

  • The specified scan settings other than ADF orientation such as the scan size, resolution, and data format are retained even if the machine is turned off.

  • When scanning starts in the scan menu that is not available with the specified setting, The specified function is not available with current settings. is displayed on the LCD. Change the setting, following the on-screen instructions.

  • When you forward the scanned data to the computer or attach the data to an e-mail, you can specify the destination and file name using Canon IJ Scan Utility.

    Settings Dialog

  • If you scan originals from the computer, you can scan with advanced settings. For details on scanning from the computer:

    Scanning Photos and Documents

figure: LCD
  1. Scan size

    Select the size of the original.

    Note
    • When Legal is selected, load the original in the ADF.

    • When 4"x6"(10x15cm), 5"x7"(13x18cm), or Auto scan is selected, load the original on the platen glass.

  2. Format

    Select the data format of the scanned data.

  3. Scan res (Scan resolution)

    Select the resolution for scanning.

  4. Preview

    Select to preview the scanned data or not when saving the data on a USB flash drive.

  5. ADF orientation

    Select the orientation of the original document.

    This setting item is not available when Photo is selected for Doc.type.

  6. Reduce show-thru (Reducing show-through)

    Characters on the back may show through when scanning a thin document such as a newspaper. Select ON if characters seem to show through on the scanned document.

    This setting item is not available when Photo is selected for Doc.type.

  7. Descreen

    A printout consists of minute dots to make characters or graphs. Interfering with each dot may result in uneven shades or a striped pattern. Select ON if you notice any uneven shades or a striped pattern on the scanned image.

    This setting item is not available when Photo is selected for Doc.type.

    Note
    • Even if ON is selected for this setting, some moire effects may remain if Unsharp mask is set to ON. In that case, select OFF for Unsharp mask.

  8. Unsharp mask

    The outline of small characters or thin objects such as a hair or leaves on a photo can be accentuated. Select ON if you want to accentuate the outline of the scanned data.

Page top