skip to main Item

imagePROGRAF TX-4200/TX-3200/TX-2200
imagePROGRAF TX-5420/TX-5320/TX-5220

Plain Paper (High Density)

  • Previous
  • Next
Item Description
Category Plain Papers
Operation Panel Plain Paper (High density)
Printer Driver Plain Paper (High Density)
Type of Black Ink MBK
Execute Color Calibration No
Factory Default PRESET
Display Region JP,CK,OC,EMEA,AM,AS
Approximate Basis Weight (g/㎡) 64
Approximate Thickness (mm) 0.09
Number of Borderless Printing Sides Four-sided Borderless
Borderless Printing Available
Automatic Cutting Eject Cut
Roll paper auto feed Supported
Automatically switch paper sources Yes
Leading Edge Cut Length (normal humidity) 100 mm
Leading Edge Cut Length (low/high humidity) 100 mm
Minimum Print Cut Length（normal humidity） 100 mm
Minimum Print Cut Length（low/high humidity） 100 mm

Important

  • Ink will take longer to dry because this setting prints at high density.

    Note the following:

    • If the ink has not dried sufficiently, ink may stick to surfaces or the printed surface may get scratched.Change [Drying Time] settings if necessary.Refer to "Specifying the Ink Drying Time for Rolls" for details.

    • The printer's [Cutting mode] is set to [Eject cut] by default.

      Use [Eject cut] when printing.If the printer's [Cutting mode] setting is changed to [Automatic cut], paper may be cut before the ink has dried sufficiently.Refer to "Specifying the Cutting Method for Rolls" for details.

    • There may be scratching at the leading or trailing edges of the printing surface, or paper jams may occur.

      To prevent this from occurring, we recommend that you create a 75 mm margin at the trailing edge of the image.

    • We recommend that you attach a basket.

      If you print without attaching a basket, ink may stain the floor.Refer to "Printing on Large-Format or Easily Damaged Paper (Position 3)" for details.

Note

  • These are general-purpose paper settings.
  • Borderless Printing
    Depending on the paper used, borderless printing may not be available.