skip to main text

Example Stacker Configurations

The stacker is used by changing the position depending on the paper size of the printed materials.

Important

  • Depending on the types of paper, it cannot be stacked in the Position 2, Position 3, or Position 4. In this case, use the Position 1.

  • Depending on the printer model, the paper size may not be supported.

Storing Printed Materials (Position 1)

Pull down the rod (fixed) (C) toward you. Set the rod (adjustable) in the groove (B) at the lower of the arm, and then set the flapper (A) vertically so that the stacker configuration is the Position 1.

Stacking Printed Materials with ARCH E Portrait or A0 Portrait (Position 2)

  • Supported paper size

    • 36"x48" (ARCH E) 36.00 x 48.00 inches (914.4 x 1219.2 mm)
    • A0 33.11 x 46.81 inches (841.0 x 1189.0 mm)

Set the rod (adjustable) in the groove (B) at the upper of the stand, and then push down the rod (fixed) (C) to the printer side. Then set the flapper (A) vertically so that the stacker configuration is the Position 2.

Stacking Printed Materials with ARCH D Portrait or A1 Portrait (Position 3)

  • Supported paper size

    • 24"x36" (ARCH D) 24.00 x 36.00 inches (609.6 x 914.4 mm)
    • A1 23.39 x 33.11 inches (594.0 x 841.0 mm)

Pull down the rod (fixed) (E) toward you. Set the rod (adjustable) in the groove (B) at the upper of the stand, and then set the flapper (A) vertically so that the stacker configuration is the Position 3. Then attach the paper stopper (C) stored in the accessory pocket of the stand to the lower of the second part (D) from the right side of the flapper.

Stacking Printed Materials with ARCH D Landscape, ARCH C Landscape, A1 Landscape or A2 Landscape (Position 4)

  • Supported paper size

    • 24"x36" (ARCH D) 24.00 x 36.00 inches (609.6 x 914.4 mm)
    • 18"x24" (ARCH C) 18.00 x 24.00 inches (457.2 x 609.6 mm)
    • A1 23.39 x 33.11 inches (594.0 x 841.0 mm)
    • A2 16.54 x 23.39 inches (420.0 x 594.0 mm)

Pull down the rod (fixed) (C) toward you. Set the rod (adjustable) in the groove (B) at the upper of the stand, and then set the flapper (A) horizontally so that the stacker configuration is the Position 4.