Cut to standard size

Specifies standard size as the output page size when printing on roll paper.

Select this setting item from Device settings > Print settings > HP-GL/2 print settings > Paper settings.

• If OFF (Initial setting) is selected:

  Cutting according to standard size is not performed.

• If ON is selected:

  Cuts to standard size in accordance with the roll paper width.

  When there are two lengths/widths applicable for a given roll paper width, the optimum size is selected automatically.

  Note

  • Nesting cannot be performed while ON is selected.
  • If ON is selected for Conserve paper and there is blank space above/below the image, the size will not be standard size.
  • When ON is selected for Print centered, printing will be in the center of the standard size.
  • If there is no standard size corresponding to the roll paper width, operation is the same as if OFF is selected. No message is displayed.

  • When there are multiple width/length candidates in the roll 1 (upper) and roll 2 (lower) in a double-roll printer model, the optimum standard size is selected automatically under the following conditions.

    • When any of the candidates accommodates the output page size, the standard size closest to the minimum image range is selected for efficient printing.
    • When none of the candidates accommodates the output page size, the largest standard size is selected to expand the print range.
  • For information about supported standard sizes, see the appendix at the back of this manual.