skip to main text

Searching Printer by IP Address or Host Name During Setup

If the printer cannot be found on the Printer Detection screen, the Connecting Printer to Network screen appears.

figure: Connecting Printer to Network screen

The Windows screen is used as an example above.

Clicking Search For IP Address allows you to search for a printer by specifying the IP address or host name of the printer.

  1. Check printer's IP address or host name.

    To check the printer's IP Address or host name, print out the network settings information or use the operation panel to display it.

    Note

    • If you use the printer in an office, ask the network administrator.

  2. Specify searching methods.

    Select one of the methods below.

    figure: Printer Search Method Selection screen

    The Windows screen is used as an example above.

    A: Search by IPv4 address
    Select to search for printers by IPv4 address.
    B: Search by IPv6 address
    Select to search for printers by IPv6 address.
    C: Search by host name
    Select to search for printers by host name. A host name is referred to as LLMNR host name or Bonjour service name.

  3. Enter IP address or host name and click Next.

    Printer search starts.

If an error screen appears:

Resolve the error according to the instruction on the screen.

If the IP address you entered is already used for another device, follow the procedure below to specify printer's IP address.

  1. Select (Network status) on HOME screen.

  2. Select Wi-Fi.

  3. Select Settings.

  4. Select Advanced.

  5. Select TCP/IP settings.

    • If you specify IPv4 address:

      1. Select IPv4.

      2. Select Yes on the displayed screen.

      3. Select IP address.

      4. Select Manual setup.

        Selecting Auto setup specifies the IP address automatically.

      5. Enter IP address.

      6. Select OK.

      7. Enter subnet mask.

      8. Select OK.

      9. Enter default gateway.

      10. Select OK.

        The IPv4 address has been specified.

    • If you specify IPv6 address:

      1. Select IPv6.

      2. Select Yes on the displayed screen.

      3. Select Enable/disable IPv6.

      4. Select Enable.

        The IPv6 address has been specified.

    Important

    • If firewall is enabled on the computer, printers on a different subnet may not be detected. Disable firewall.

If firewall interferes with printer search:

  • If a firewall message appears:

    If a firewall message appears warning that Canon software is attempting to access the network, set the security software to allow access.

    After allowing the software to access, specify the IP address or host name and search for printers again.

    If the printer is found, follow the instructions on the screen to continue to set up the network communication.

  • If no firewall message appears:

    Temporarily disable the firewall and specify the IP address or host name to search for printers again.

    After the setup is complete, re-enable the firewall.

Note

  • For more on firewall settings of your operating system or security software, see instruction manual or contact its manufacturer.