Print settings

• Prevent paper abrasion

  Use this setting only if the print surface becomes smudged.

  Important

  • Be sure to set this back to OFF after printing since it may result in lower printing speed or lower print quality.

• Extended copy amount

  Selects the amount of image that extends off the paper when printing in borderless (full).

  Slight cropping may occur at the edges since the copied image is enlarged to fill the whole page. You can change the width to be cropped from the borders of the original image as needed.

  Important

  • This setting can be applied under the following conditions:

    • Performing borderless copying

    • Borderless is selected for Border when copying printed photos

  Note

  • If printouts contain margins even though you are printing in Borderless, specifying Extended amount: Large for this setting may help solve the problem.

• Adjust disc print area

  You can adjust the disc printing area if the image is not aligned with the printable disc. You can adjust the printing area in increments of 0.003 inches/0.1 mm between -0.03 inches/-0.9 mm and +0.03 inches/+0.9 mm.

• Auto photo fix setting

  When ON is selected, you can select whether to print photos using the Exif information recorded in the image files when Default* or On is selected in printing with a PictBridge (Wi-Fi) compliant device.

  * When Default is selected for the print setting on the PictBridge (Wi-Fi) compliant device, select Auto photo fix for Photo fix in PictBridge settings.

• Adjust horizontal print position

  Adjusts the print position when the left/right margins are not aligned.

  You can adjust the left/right margins in increments of 0.01 inch/0.1 mm between -0.12 inch/-3 mm and +0.12 inch/+3 mm centered on the horizontal center of the paper.

  Important

  • For Letter-sized or Legal-sized paper, you can adjust the left/right margins between -0.06 inch/-1.5 mm and +0.06 inch/+1.5 mm even if you specify the value over 0.06 inch/1.5 mm.