skip to main text

Print settings

  • Prevent paper abrasion

    Use this setting only if the print surface becomes smudged.

    Important

    • Be sure to set this back to OFF after printing since it may result in lower printing speed or lower print quality.

  • Amount of extension

    Selects the amount of image that extends off the paper when printing in borderless (full).

    When performing Borderless Printing, slight cropping may occur at the edges since the printed image is enlarged to fill the whole page. You can change the width to be cropped from the borders of the original image as needed.

    Important

    • Settings will become ineffective in the following situations:

      • Printing from a PictBridge (Wi-Fi) supporting device.

      • Printing from a standard form.

    Note

    • When performing settings from application software or the printer driver, these settings will be prioritized.

    • If printouts contain margins even though you are printing in Borderless, specifying Extended amount: Large for this setting may help solve the problem.

  • Auto photo fix settings

    When ON is selected, you can select whether to print photos using the Exif information recorded in the image files in the following cases.

    • Auto photo fix is selected for Photo fix when printing from a memory card.

    • The print setting on the PictBridge (Wi-Fi) compliant device is set to Default* or On when printing with a PictBridge (Wi-Fi) compliant device.

      * When Default is selected for the print setting on the PictBridge (Wi-Fi) compliant device, select Auto photo fix for Photo fix in PictBridge settings.

  • Adjust horizontal print position

    Adjusts the print position when the left/right margins are not aligned.

    You can adjust the left/right margins in increments of 0.004 in. (0.1 mm) between -0.12 in. (-3 mm) and +0.12 in. (+3 mm) centered on the horizontal center of the paper.

    Important

    • For Letter-sized or Legal-sized paper, you can adjust the left/right margins between -0.06 in. (-1.5 mm) and +0.06 in. (+1.5 mm) even if you specify the value over 0.06 in. (1.5 mm).