Cut to standard size

Specifies standard size as the output page size when printing on roll paper.

This setting item is displayed by tapping in the following order.

(Setup) > Device settings > Print settings > HP-GL/2 print settings > Paper settings

• ON

  Cuts to standard size in accordance with the roll paper width.

  When there are two lengths/widths applicable for a given roll paper width, the optimum size is selected automatically.

  Note

  • Nesting cannot be performed while ON is selected.
  • If ON is selected for Conserve paper and there is blank space above/below the image, the size will not be standard size.
  • When ON is selected for Print centered, printing will be in the center of the standard size.
  • If there is no standard size corresponding to the roll paper width, operation is the same as if OFF is selected. No message is displayed.
  • For information about supported standard sizes, see Standard Size Table.

• OFF (Initial setting)

  Cutting according to standard size is not performed.