Cut to standard size

Specifies standard size as the output page size when printing on roll paper.

Display this item by selecting the following.

(Setup) > Printer settings > Print settings > HP-GL/2 print settings > Paper settings

• ON

  Cuts to standard size in accordance with the roll paper width.

  When there are two lengths/widths applicable for a given roll paper width, the optimum size is selected automatically.

  Note

  • Nesting cannot be performed while ON is selected. (TM-355/TM-255/TM-5355/TM-5255)
  • If ON is selected for Save paper and there is blank space above/below the image, the size will not be standard size.
  • When ON is selected for Print centered, printing will be in the center of the standard size.
  • If there is no standard size corresponding to the roll paper width, operation is the same as if OFF is selected. No message is displayed.
  • For information about supported standard sizes, see Standard Size Table.

• OFF

  Cutting according to standard size is not performed.