LAN settings

• Wi-Fi

  Enables/Disables Wi-Fi.

• Wireless Direct

  Enables/Disables Wireless Direct.

• Wired LAN

  Enables/Disables Wired LAN.

• Confirm LAN settings

  The LAN setting information is displayed.

• Advanced setup

  • Set printer name

    Specifies the printer name.

    Note

    • You cannot use the same printer name as that already used for other LAN connected devices.
    • You cannot use a hyphen for the initial or last character of the printer name.

  • TCP/IP settings

    Performs IPv4 or IPv6 setting.

  • WSD settings

    Perform settings to use WSD.

  • Bonjour settings

    Perform settings to use Bonjour.

  • LPD print

    Perform settings for printing with LPD.

  • SNMP settings

    Perform settings for using SNMP to manage and control the printer.

  • SNTP settings

    Perform settings for using SNTP to adjust the time on the printer.

  • FTP settings

    Perform settings for printing with FTP.

  • IPP Settings

    Perform settings for printing with IPP.

  • CHMP settings

    Perform settings for communication at the time when printer drivers or applications acquire the information on status, paper, and job log, from the printer.

    Selecting Enable HTTPS redirection redirects the communication using CHMP to encrypted communication.

    Note

    • To use CHMP for encrypted communication, you need to register the printer's root certificate to your computer.
    • Registering Printer's Root Certificate to Local Computer for SSL Communication
    • CHMP is a Canon proprietary protocol.

  • Network interface settings

    To connect to a hub that supports spanning tree, select Spanning tree settings > Enable.

    Selecting Enable avoids circulating data on a network.

  • DRX settings

    When enabled, data is received intermittently during network connection.

  • IP filtering

    Allows or denies access for specific IP addresses.

    Settings for both IPv4 and IPv6 addresses can be specified.

    Important

    • If the device address for the administrator has been set to rejection by mistake, select LAN settings on the HOME screen of the operation panel, and then select Wi-Fi / Wireless Direct / Wired LAN > Settings > Advanced > Reset LAN settings in this order, and initialize network information of the printer.

      After resetting, perform setup again as necessary.

  • MAC address filtering settings

    Allows or denies access for specific MAC addresses.

    Important

    • If the device address for the administrator has been set to rejection by mistake, select LAN settings on the HOME screen of the operation panel, and then select Wi-Fi / Wireless Direct / Wired LAN > Settings > Advanced > Reset LAN settings in this order, and initialize network information of the printer.

      After resetting, perform setup again as necessary.

  • Reset LAN settings

    Initializes the network settings on the printer.

    After resetting, perform setup again as necessary.