Roll Paper Remains/Lacks under Quantity Management

  1. Check 1 Is the remaining amount of loaded roll paper set correctly?

    If all of the following conditions are met, you can specify the remaining amount of the loaded roll paper manually when you load it.

    • Barcodes is selected for Manage remaining roll amount.
    • Enable is selected for Roll paper auto feed.
    • Auto detect or Use current media type is selected for Media type selection method.

    You must specify the remaining amount of roll within about five seconds. If you do not, the roll length specified on Advanced paper settings is regarded as the default value.

    The difference between the value and actual length of loaded roll paper makes the remaining amount large or small.

  2. Check 2 Check the setting of Manage remaining roll amount.

    • If Barcodes is selected for Manage remaining roll amount:

      1. Enter Length of roll paper 1 and Length of roll paper 2, and tap OK.

      2. Select the timing of warning messages from Roll amount warning settings.

    • If Auto estimate is selected for Manage remaining roll amount:

      Make sure the media type is configured correctly.

      Make sure Paper core outer diameter and Paper thickness are configured correctly for Advanced paper settings.

      Note

      • Paper core outer diameter and Paper thickness must be set correctly for auto estimation to be accurate.
      • Contact the media manufacturer for paper core outer diameter and paper thickness.
      • For pre-registered paper, the paper core outer diameter and paper thickness are set, but they may be changed at the convenience of the media manufacturer.
      • If you want to use paper that is not displayed in the paper information list, set the paper thickness and paper core outer diameter in the Media Configuration Tool.