Adjusting Line Length
To ensure that lines in CAD drawings are printed at exactly the right length, use Adjust feed length to adjust the amount that paper is advanced.
There are two options in Adjust feed length : Print alignment pattern and Change adjustment values.
Note
- We recommend executing the adjustment if you have changed the paper type or paper size.
-
Always check the Set priority values before adjustment.
Items to Prepare
When Using Rolls |
|
When Using Sheets |
|
Follow the procedure below to adjust.
-
Load paper.
- Loading Rolls on the Roll Holder
- Loading the Upper Roll on the Printer
- Loading Sheets in the Printer
Important
-
Always make sure the loaded paper matches the type of paper specified.
Adjustment cannot be completed correctly unless the loaded paper matches the settings.
-
Flick HOME screen and tap Maintenance.
-
Tap Paper feed adjustment.
-
Tap Adjust feed length.
-
Tap Print alignment pattern or Change adjustment values.
-
If you tap Print alignment pattern:
The test pattern is printed for you to measure the scale and calculate the discrepancy.
The scale bar prints "Millimeter" in 50 mm increments and "Inch" in 1-inch increments.
-
If you tap Change adjustment values:
No test pattern is printed.
Instead, you will measure a document already printed to determine the discrepancy.
-
-
Tap amount of discrepancy.
If the scale is shorter than the actual size, use a positive setting value.
If it is longer, use a negative value.
The feed amount can be adjusted in 0.02% increments.