skip to main Item

imagePROGRAF PRO-4000S

Highest Density Backlit Film

  • Previous
  • Next
Item Description
Category Sign
Operation Panel HighDensityBacklit
Printer Driver Highest Density Backlit Film
ICC Profile (Displayed Name) Canon PRO-4000S/540S Highest Density Backlit Film -P
ICC Profile (File Name) CN_PRO-4000S_540S_HighestDensityBacklitFilm-P.icc
Type of Black Ink MBK
Execute Color Calibration No
Tone Adjustment Not possible
Factory Default MCT
Display Region JP,CK,AS,OC,EMEA,AM
Approximate Basis Weight (g/㎡) 165
Approximate Thickness (mm) 0.13
Number of Borderless Printing Sides Four-sided Borderless
Borderless Printing Available
Automatic Cutting Eject Cut
Leading Edge Cut Length (normal humidity) 30 mm
Leading Edge Cut Length (low/high humidity) 30 mm

Important

  • Ink will take longer to dry because this setting prints at high density.

    Note the following:

  • Allow enough time for drying.

    If the ink has not dried sufficiently, ink may stick to surfaces or the printed surface may get scratched.Change [Drying Time] settings if necessary.Refer to "Specifying the Ink Drying Time for Rolls" for details.

  • The printer's [Cutting mode] is set to [Eject cut] by default.

    Use [Eject cut] when printing.If the printer's [Cutting mode] setting is changed to [Automatic cut], paper may be cut before the ink has dried sufficiently.Refer to "Specifying the Cutting Method for Rolls" for details.

  • It is recommended to use the basket in Position 3.

    The ink may stick to the basket if you use it in other positions.Refer to "Printing on Large-Format or Easily Damaged Paper (Position 3)" for details.

Note

  • These are general-purpose paper settings.
  • If you see uneven printing in the printed material, you can alleviate the problem by aligning the backlight.
  • In environments that are exposed to water, after printing the document, laminate the document or perform other appropriate processing before you use it.