Print settings

• Prevent paper abrasion

  Use this setting only if the print surface becomes smudged.

  Important

  • Be sure to set this back to OFF after printing since it may result in lower printing speed or lower print quality.

• Extended copy amount

  Selects the amount of image that extends off the paper when printing in borderless (full).

  Slight cropping may occur at the edges since the copied image is enlarged to fill the whole page. You can change the width to be cropped from the borders of the original image as needed.

  Important

  • This setting can be applied under the following conditions:

    - Performing borderless copying

    - Borderless is selected for Border when copying printed photos

  Note

  • If printouts contain margins even though you are printing in Borderless, specifying Extended amount: Large for this setting may help solve the problem.

• Prevent paper double-feed

  Select ON to prevent double-feed of plain paper.

  Important

  • Select ON only when double-feed of plain paper occurs.

• Adjust horizontal print position

  Adjusts the print position when the left/right margins are not aligned.

  You can adjust the left/right margins in increments of 0.003 inches/0.1 mm between -0.1 inches/-3 mm and +0.1 inches/+3 mm centered on the horizontal center of the paper.

  Important

  • For Letter-sized or Legal-sized paper, you can adjust the left/right margins between -0.05 inches/-1.5 mm and +0.05 inches/+1.5 mm even if you specify the value over 0.05 inches/1.5 mm.