Making Copies on Plain Paper

Load the original on the platen glass to copy.

1. Make sure that the printer is turned on.

2. Load A4 or Letter-sized plain paper.

3. Load the original on the platen glass.

   Note

   • You can switch the size of paper loaded in the rear tray between A4 and Letter.

     • Switching Page Size between A4 and Letter

4. Press the Color button for color copying, or the Black button for black & white copying.

   The printer starts copying.

   Remove the original on the platen glass after copying is complete.

   To make multiple copies

   Press the Color button or the Black button repeatedly according to the number of copies you want.

   Press the same button (Color button or Black button) as the one which you previously pressed.

Important

• Do not open the document cover or remove the original from the platen glass until scanning is completed.

  While the printer is scanning the original, the ON lamp keeps flashing.

• If the original covers the whole page, area (B) in the figure below cannot be printed.

  

  (A) The direction in which the paper is ejected

  (B) Unprintable area

  For details on the printable area:

  • Standard Sizes

Note

• To cancel copying, press the Stop button.

• To set the print quality to "Draft" (speed priority)

  You can set the print quality to "Draft" (speed priority) following the procedure below.

  1. Press and hold down the Color or Black button for 2 or more seconds in step 4.

     The ON lamp flashes once.

  2. Release the button.

     The printer starts copying.

  When the print quality is set to "Draft", print speed is given priority over quality. To give priority to quality, press the Color or Black button for less than 2 seconds to copy in the print quality "Standard".