skip to main text

Searching Machine by IP Address or Host Name During Setup (Windows)

If the printer cannot be found on the Select Printer screen, search for the printer by an IP address or host name. Select Specify the IP address and run the search radio button and click Next. The screen to select searching criteria appears.

  1. Check printer's IP address or host name.

    To check the printer's IP Address or host name, print out the network settings information or use the operation panel to display it.

    Note

    • If you use the printer in an office, ask the network administrator.

  2. Specify searching method.

    Select one of the method below.

    figure: Printer Search Method Selection screen

    1. Search by IPv4 address

      Select to search for printers by IPv4 address.

    2. Search by IPv6 address

      Select to search for printers by IPv6 address.

    3. Search by host name

      Select to search for printers by host name. A host name is referred to as LLMNR host name or Bonjour name.

  3. Enter IP address or host name and click Next.

    Printer search starts.

If an error screen appears:

Resolve the error according to the instruction on the screen.

If the IP address you entered is already used for another device, follow the procedure below to specify printer's IP address.

  1. Select Setup on HOME screen.

  2. Select Device settings and press OK button.

  3. Select LAN settings and press OK button.

    If you specify the administrator password, enter the password.

  4. Select Other settings and press OK button.

  5. Select TCP/IP settings and press OK button.

    If you specify IPv4 address:

    1. Select IPv4 and press OK button.

    2. Select Yes on displayed screen and press OK button.

    3. Select IP address and press OK button.

    4. Select Manual setup and press OK button.

      Selecting Auto setup and pressing the OK button specifies the IP address automatically.

    5. Enter IP address.

    6. Select OK and press OK button.

    7. Enter subnet mask.

    8. Select OK and press OK button.

    9. Enter default gateway.

    10. Select OK and press OK button.

      The IPv4 address has been specified.

    If you specify IPv6 address:

    1. Select IPv6 and press OK button.

    2. Select Yes on displayed screen and press OK button.

    3. Select Enable/disable IPv6 and press OK button.

    4. Select Enable and press OK button.

      The IPv6 address has been specified.

    Important

    • If firewall is enabled on the computer, printers on a different subnet may not be detected. Disable firewall.

If firewall interferes with printer search:

  • If message appears:

    If a message appears warning that Canon software is attempting to access the network, set the security software to allow access.

    After allowing the software to access, specify the IP address or host name and search for printers again.

    If the printer is found, follow the instructions on the screen to continue to set up the network communication.

  • If no message appears:

    Cancel searching printers, and then set the security software to allow Canon software below to access the network.

    Setup.exe or Setup64.exe in the win > Driver > DrvSetup folder on the Setup CD-ROM

    After setting the security software, specify the IP address or host name and search for printers again.

Note

  • For more on firewall settings of your operating system or security software, see instruction manual or contact its manufacturer.