Firmware update

Important

• The administrator password is required to change the settings if it is enabled to change the settings on the operation panel using the administrator password.

• When you use this function, make sure the printer is connected to the Internet.

• Install update

  Performs the firmware update of the printer. If you select Yes, the firmware update starts. Follow the on-screen instructions to perform update.

  Note

  • If the firmware update is not complete, check the following and take an appropriate action.

    • Check the network settings.

    • If Cannot connect to the server. is displayed on the touch screen, select OK and try again after a while.

• Check current version

  You can check the current firmware version.

• Update notification settings

  You can set the printer to display the firmware update information on the touch screen when the firmware update is available.

  When Idle/Power off is selected, the printer informs you of the update during idle and the update information also appears when you press the ON button.

• DNS server setup

  Performs settings for a DNS server. Select Auto setup or Manual setup. If you select Manual setup, follow the display on the touch screen to perform settings.

• Proxy server setup

  Performs settings for a proxy server. Follow the display on the touch screen to perform settings.