skip to main text

Replacing the Maintenance Cartridge

In case of cautions or errors concerning the maintenance cartridge, an error message will appear on the touch screen to inform you of the error. Take appropriate action as prompted by the message.

Watch the movie

Important

  • If a message is displayed indicating that the maintenance cartridge is nearly full, replace the maintenance cartridge as soon as possible. If the maintenance cartridge becomes full, an error message is displayed and the printer stops working until the cartridge is replaced with a new one.

  • Do not touch the terminal (A) of the maintenance cartridge.

    Image showing the maintenance cartridge
  • Do not turn off the printer during replacement of the maintenance cartridge.

Note

  • Use a maintenance cartridge with the model number below.

    Maintenance Cartridge MC-G03

  1. Prepare a new maintenance cartridge.

    Remove the maintenance cartridge and the attached plastic bag from the package.

  2. Open the scanning unit / cover (B).

    Check the position of the maintenance cartridge (C).

    Important

    • Do not touch tubes or other parts inside the printer. This can cause trouble with the printer.

    • Do not put your hands inside the printer, as ink may adhere to your hands.

  3. Slide the maintenance cartridge until the arrow mark on the maintenance cartridge is aligned with the unlock mark on the printer.

  4. Lift the maintenance cartridge and remove it.

    Important

    • Do not drop the removed maintenance cartridge as ink may spill.

      Do not place the removed maintenance cartridge on a desk or other surface, as there may be ink on the bottom of the cartridge.

    • To prevent ink from leaking, do not tilt the removed maintenance cartridge or turn it upside down.

    • Put the used one immediately into the plastic bag that came with the new maintenance cartridge and seal the bag by tying the opening tightly to prevent the ink from leaking.

  5. Insert a new maintenance cartridge.

  6. Slide the maintenance cartridge until the arrow mark on the maintenance cartridge is aligned with the lock mark on the printer.

  7. Close the scanning unit / cover.

    To close the scanning unit / cover, lift it up slightly and then lower it gently.