LAN settings

Wi-Fi

Enables/Disables Wi-Fi.
Wireless Direct

Enables/Disables Wireless Direct.
Wired LAN

Enables/Disables Wired LAN.
Confirm LAN settings

The LAN setting information is displayed.
Advanced setup
- Set printer name
  
  Specifies the printer name. You can use 2 to 15 characters for the name.
  
  Note
  - You cannot use the same printer name as that already used for other LAN connected devices.
  - You cannot use a hyphen for the initial or last character of the printer name.
- TCP/IP settings
  
  Performs IPv4 or IPv6 setting.
- WSD settings
  
  Perform settings to use WSD.
- Bonjour settings
  
  Perform settings to use Bonjour.
- LPD print
  
  Perform settings for printing with LPD.
- SNMP settings
  
  Perform settings for using SNMP to manage and control the printer.
- SNTP settings
  
  Perform settings for using SNTP to adjust the time on the printer.
- FTP settings
  
  Perform settings for printing with FTP.
- IPP Settings
  
  Perform settings for printing with IPP.
- CHMP settings
  
  Perform settings for communication at the time when printer drivers or applications acquire the information on status, paper, and job log, from the printer.
  
  Selecting Enable HTTPS redirection redirects the communication using CHMP to encrypted communication.
  
  Note
  - To use CHMP for encrypted communication, you need to register the printer's root certificate to your computer.
  - CHMP is a Canon proprietary protocol.
- Network interface settings
  
  To connect to a hub that supports STP, select Enable.
  
  Selecting Enable perform the intermittent data reception when connecting to the network.
- DRX settings
  
  Selecting Enable perform the intermittent data reception when connecting to the network.
- IP filtering
  
  Allows or denies access for specific IP addresses.
  
  Settings for both IPv4 and IPv6 addresses can be specified.
  
  Important
  - If the device address for administrator has been set to rejection by mistake, tap (Network) on the HOME screen of the operation panel, and then tap LAN settings > Wi-Fi / Wireless Direct / Wired LAN > Settings > Advanced setup > Reset LAN settings, and initialize network information of the printer.
    
    After resetting, perform setup again as necessary.
- MAC address filtering settings
  
  Allows or denies access for specific MAC addresses.
  
  Important
  - If the device address for administrator has been set to rejection by mistake, tap (Network) on the HOME screen of the operation panel, and then tap LAN settings > Wi-Fi / Wireless Direct / Wired LAN > Settings > Advanced setup > Reset LAN settings, and initialize network information of the printer.
    
    After resetting, perform setup again as necessary.
- Reset LAN settings
  
  Initializes the network settings on the printer.
  
  After resetting, perform setup again as necessary.